Hey guys I thought I would post up some progress of the jeeps that I work on from time to time as well as building parts.
Here are some pics of the 2 door I have been working on in my spare time
Its a 1990 2 door split window with about 6-7" of lift on 35s
I set up a longer than usual long arm system for a smoother ride at speed I was going to build it for ECORS but I just don't have the time for that yet. so I am probably going to have to sell it so I can buy more equipment and build another one later.
This is my high steer set up. I did not want to spring for a tera knuckle but by properly machining The extra spacer for misalignment and then properly welding it later with high silicon wire it will be more than strong enough.
Axle in place. I installed my poly bushing kit and used 95d poly with this. I send out 88 with my kit i sell but I wanted this axle to be extra firm.
This shows my rear mounting of the arms behind the cross member for longer setup. I used a laser cut 5/16 bracket made from 100a steel. These are stronger than 3/8 hot rolled plate.
I used the stock cross member because I would like to go that direction with my long arm kits to provide long arms for a better value.
Note the 3" of thread showing. There is still 3.5 inches of 1.5" thread still in the arm. Also note: no welded tube insert. The arms are threaded internally 6" deep. The tubing is 2" x.281 DOM
Track bar bracket. The cross brace and track bar in powder coat.
A
Bookmarks