i made mine out of 1.5x1.5" 120 wall square tube and just welded a couple bolts through it to mount the shocks only prob i had was i used 1/8th" plate for where it mounts to the unibody and its was bent after the first run (the plate not the tube)so just make sure to use thicker plate steel like 3/16" where it bolts on the unibody where the old bumpstops used to be it was super easy and cheap to make the only reason i did it was because i relocated the axle shock mounts then my shocks were too long so i had to mount them at an angle so i had some uptravel without bottoming out the shock