I just picked up a junkyard front shaft, by the part number/length its a 89-01 4.0 auto one to use with the IRO hack and tap I'm about to install.
Unfortunately, its missing the grease zerk on the slip joint. Does anyone know what size that is?
Tapatalk is active for this site! Just go to your phone's store to download and install.
I just picked up a junkyard front shaft, by the part number/length its a 89-01 4.0 auto one to use with the IRO hack and tap I'm about to install.
Unfortunately, its missing the grease zerk on the slip joint. Does anyone know what size that is?
There are only two "sizes" for the small zerk fittings and they are 1/4X28 and the metric equivalent. Almost certain it is a 1/4X28
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Bookmarks