Anyone know how to install a front bumpstop without removing the coil spring. Cannot figure this one out....
Tapatalk is active for this site! Just go to your phone's store to download and install.
Anyone know how to install a front bumpstop without removing the coil spring. Cannot figure this one out....
As in spacing it out or just plain installing it?
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
It seems like it will just push in but how do i get coil spring spread enough to get it in there...
I can usually snake mine in. Have you jacked the vehicle up and let the axle droop?
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Have not tried anything yet. Should i put opposite side on cinder block then jack and force that side to drop spreading the coil,
Support the frame, then remove the wheel and let the axle drop
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Good idea. I was replacing shocks and noticed the bumpstomp fell out. Will try that when i get new one
Bookmarks