Don't know where to put this...
Is the housing savable? I'm not worried about the gouges in the back, but I'm worried about the spots by the bearing caps. I'm assuming the pinion race is replaceable.
Tapatalk is active for this site! Just go to your phone's store to download and install.
Don't know where to put this...
Is the housing savable? I'm not worried about the gouges in the back, but I'm worried about the spots by the bearing caps. I'm assuming the pinion race is replaceable.
Originally Posted by CherokeeCountry
As long as there are no cracks, yes. If there are any burrs on the edge, those can be removed. You were going to regear anyway right?
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
So just get rid of these burrs and run it?
Going to 4.88s and full width I think.
Last edited by 89Laredo; 04-27-2013 at 03:57 PM.
Originally Posted by CherokeeCountry
Yes, take a dremel and knock off any little burs on the edge. It is the machined surface as a whole that counts. Those surfaces hold the bearing race, but also act as an alignment device. So as long as the bearing race will fit in there straight and the caps go down all the way it will be good
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Bookmarks