Re: D44 Saveable?
Yes, take a dremel and knock off any little burs on the edge. It is the machined surface as a whole that counts. Those surfaces hold the bearing race, but also act as an alignment device. So as long as the bearing race will fit in there straight and the caps go down all the way it will be good
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Bookmarks