Re: AXLE side of the upper control arm bushing
Scott
They are the same bushing. However they are tapered. If you are fabbing, you can use almost anything. If you are doing a three link, the upper bushings are not tough enough. You would be better off using a lower bushing, they are much stronger and will last.
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Bookmarks