Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Level: Jeep Compass
Re: problem with UCA bushing at axle
The bushings I picked up fit into the upper control arm but fall out of the houshing (no press fit). I am guessing that the bore in the housing is bad. If I can't find an oversized bushing I will probably just weld a couple beads in the bore and cram the bushing in there until I can pick up another housing.
I will post up a pic and the part # for you tomorrow.
Last edited by bentandtwisted; 02-13-2012 at 11:18 PM.
Posting Permissions
Reply With Quote
Bookmarks