Re: Noob here. Hope to get some guidance
The regulators have to be left and right. I doubt you can repair it, but anything is possible. To say for sure, you will have to take the door panel off and inspect it. If you have to replace it, then you will have to drill the pop rivets out with a 1/4" bit. To install, use 1/4X12" allen head screws with nylock nuts. !/4" pop rivet guns are lots of dollars.
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Bookmarks