Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Level: Jeep Liberty
Re: Death wobble bedammmmmmmned !!!!!!!
Thanks I have already ruled out that part I discovered a fair amount of play in both ball joints in fact can you tell me this when I removed the top ball joint from the mounting point on my front axle I was able to slide the threaded shaft out an additional 3/4" from the body but it was not sloppy just came out more is this normal?
And for those of you who say if no pictures then it did'nt happen I will post them in a few!!!!!!!
Last edited by pyrotech; 08-27-2011 at 08:11 AM.
1996 xj 4.0 HO 2-5"drv.lights 2-4"pencil beam spots on bumper,urethane control arm bushings,urethane track bar bushings, elec.fan, RR header, magna flo high flo cat,40 series flowmaster with full 2.50" pipe out to bumper,home brewed cold air setup,5.50" super lift coils in front,S10 bastard pack in rear with 5.75" of lift ,31x10.50x15 pro comp xtreme terrains on 05 jeep limited alloys! It only cost me250.00 for the xj
Posting Permissions
Reply With Quote
Bookmarks