so last night i was driveing my 87 5speed an blew out my u joint. I have the dana 35. so my question is will the chrysler axle bolt up with the same u joints ? i found one for a relly good deal on craigslist for 140
Tapatalk is active for this site! Just go to your phone's store to download and install.
so last night i was driveing my 87 5speed an blew out my u joint. I have the dana 35. so my question is will the chrysler axle bolt up with the same u joints ? i found one for a relly good deal on craigslist for 140
IF I WANTED A HUMMER I WOULD HAVE ASKED YOUR DAUGHTER
As far as I know they use the same u-joints. But the d35 driveshaft is 1" longer than the 8.25. Shouldn't be a problem if you have some lift.
i havent put the lift on it yet do you think i could run the 8.25 drive shaft with my ba10 trans?
IF I WANTED A HUMMER I WOULD HAVE ASKED YOUR DAUGHTER
Bookmarks