so last night i was driveing my 87 5speed an blew out my u joint. I have the dana 35. so my question is will the chrysler axle bolt up with the same u joints ? i found one for a relly good deal on craigslist for
140
Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Level: Hummer (H2)
87 cherokee
IF I WANTED A HUMMER I WOULD HAVE ASKED YOUR DAUGHTER
Mall Crawler
Re: 87 cherokee
As far as I know they use the same u-joints. But the d35 driveshaft is 1" longer than the 8.25. Shouldn't be a problem if you have some lift.
Level: Hummer (H2)
Re: 87 cherokee
i havent put the lift on it yet do you think i could run the 8.25 drive shaft with my ba10 trans?
IF I WANTED A HUMMER I WOULD HAVE ASKED YOUR DAUGHTER
Reply With Quote
Bookmarks