Can someone tell me where this hose/tube goes? Its on the AW4 tranny. It starts at the top corner of the rear on the drivers side. I'm not finding anywhere it can go. Help is appreciated, Thanks
Here is where it starts:
Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Level: Hummer (H3)
AW4 Tranny tube/hose question
Can someone tell me where this hose/tube goes? Its on the AW4 tranny. It starts at the top corner of the rear on the drivers side. I'm not finding anywhere it can go. Help is appreciated, Thanks
Here is where it starts:
Level: Cherokee XJ
Re: AW4 Tranny tube/hose question
vent line, I had a hanger too, it was once upon a time ziptied to the NSS wiring.
1995 XJ SPORT 4.0L / AW4 / NP231 / 4" Homebrew Lift w. Hacked Fenders / Disconnected / 48" Jack / Bedlined Floor & Exterior / 33" Eldorado MTZ / Stock Axles / Twin Rack Lights / Custom Bumper with 8500LB Winch / Stiffys and a load of steel that needs to find a place on my heep.
______ooo
/ _/|_|_|\___\___
|/ : \_|_|_/ : \ |iiii|
( _ ) _ ) . ( _ ) _ )
Dirty to the C.O.R.E.
Cumberland Off Road Enthusiasts
Level: Cherokee XJ
Re: AW4 Tranny tube/hose question
If you leave it hanging, it will dribble tranny fluid.
1995 XJ SPORT 4.0L / AW4 / NP231 / 4" Homebrew Lift w. Hacked Fenders / Disconnected / 48" Jack / Bedlined Floor & Exterior / 33" Eldorado MTZ / Stock Axles / Twin Rack Lights / Custom Bumper with 8500LB Winch / Stiffys and a load of steel that needs to find a place on my heep.
______ooo
/ _/|_|_|\___\___
|/ : \_|_|_/ : \ |iiii|
( _ ) _ ) . ( _ ) _ )
Dirty to the C.O.R.E.
Cumberland Off Road Enthusiasts
Level: Cherokee XJ
Re: AW4 Tranny tube/hose question
x2 on the vent/breather hose. I added a short section hose to it so it sits above my engine.
Level: Hummer (H3)
Re: AW4 Tranny tube/hose question
I thought it may be but wasn't sure. I just noticed it hanging yesterday, so It must have just came loose a fell. So there are two vent lines on the AW4? I knew about the one at the top front of the tranny by the bell housing with the white cap on it.
Last edited by imthehink; 03-29-2011 at 03:25 PM.
Super Moderator
Re: AW4 Tranny tube/hose question
It is supposed to be bolted to the top bolt on the bell housing
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Level: Hummer (H3)
Re: AW4 Tranny tube/hose question
Thanks a lot everyone
Posting Permissions
Reply With Quote
Bookmarks