im gettin a 97 tj motor to put in my 88
what all will i have to do i wanna try to keep the H.O. head and intake
Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Level: Jeep Commander
tj 4.0 in 88xj
im gettin a 97 tj motor to put in my 88
what all will i have to do i wanna try to keep the H.O. head and intake
Level: Uber Jeep Cherokee Trailer Queen
Sounds like a chore. Alot more electronic gibberish on the TJ motor.
Moderator Emeritus
Electronics don't match. You will need to transfer the Renix TB to the HO intake after making a 4x3 bolt plate. You need the Renix flexplate and dizzy to get it to run. You may need the Renix CPS as well. The TJ has no place for the knock sensor so that gives the ECU a loss of signal but that is OK unless you get some bad fuel.
That is off the top what comes to mind to convert the TJ engine to work in a Renix era XJ.
good luck its quite a bit of work.
Level: Jeep Commander
well now i might be gettin a 92 4.0 bc the guy i was gettin the 97 from sold it even though i told him i would take it
Yea if it was a '91 ^ it would be alot easier but still alot of work.
Moderator Emeritus
The electronics are still a problem between OBDI and Renix. Most of the same things I mentioned above would still apply.
Level: Jeep Commander
what if i got the wiring and computer from it also would i be able to basically throw it in hook to power and go
Posting Permissions
Reply With Quote
Bookmarks