jeep: 89, 4.0L, 4x4, auto, np231
front axle Dana 30 with cad.
i am fixing to put a lockright in. i have been reading i have to rip out cad and get a solid axle. is this true?
thanks
Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Level: Jeep Liberty
dana 30 with CAD question
jeep: 89, 4.0L, 4x4, auto, np231
front axle Dana 30 with cad.
i am fixing to put a lockright in. i have been reading i have to rip out cad and get a solid axle. is this true?
thanks
Mall Crawler
Re: dana 30 with CAD question
I don't see how it would be a problem to leave the CAD, but im not sure. I will ask around and see what I can find out.
Level: Jeep Liberty
Re: dana 30 with CAD question
where do you wheel bigjim? im in kingwood. we got some woods where we go.
Super Moderator
Re: dana 30 with CAD question
Not a real problem. There will be a slight drag on the driver side because it will be turning all the drive train from there. If it is a problem, you can permanently lock the CAD for about 25 cents and call it good.
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Level: Hummer (H3)
Re: dana 30 with CAD question
If you're going to leave the CAD why not just weld the spiders and disco everytime you hit pavement?
Posting Permissions
Reply With Quote
Bookmarks