Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Newbie
fuel pump sending unit problem...
I have a fuel pump sending unit problem. I replaced the fuel pump in The Nasty yesterday with a used one from the jy. Everything went ok, other that the fact it was 30 degrees outside and I froze my butt off. The only problem now is my fuel gauge reads empty and I just filled up this morning. I double checked the pump positioning and it is correct. The only thing i can think of is, I must have plugged it in wrong. But I thought the plug only went together one way. Anyone have an idea?
Super Moderator
Re: fuel pump sending unit problem...
Switch
you may have interrupted the ground for the tank. Also, IIRS there are some spade connectors inside that might have come loose. You might have to pull it again to check those and the float. If you pull it, cycle it and make sure the gage moves.
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Posting Permissions
Reply With Quote
Bookmarks