well something came up and i wasnt able to go wheeling today, so i went to the shop.

ive been working on this for a while in my spare time, building rock rings.

started out with a piece of backing board and made a template




test fitting the template and did some trimming and made the one hole bigger where the valve stem is






rough cut


cleaned it up and beveled the edges


cleaned the edge of the wheel


heres a test weld after tacking


welded in


cleaned up and painted


now i just have to do 3 more and install my inner airlocks, then wrap the 35's around them. dont worry i am going to replace the valve stem.