well something came up and i wasnt able to go wheeling today, so i went to the shop.
ive been working on this for a while in my spare time, building rock rings.
started out with a piece of backing board and made a template
test fitting the template and did some trimming and made the one hole bigger where the valve stem is
rough cut
cleaned it up and beveled the edges
cleaned the edge of the wheel
heres a test weld after tacking
welded in
cleaned up and painted
now i just have to do 3 more and install my inner airlocks, then wrap the 35's around them. dont worry i am going to replace the valve stem.
Bookmarks