If you checked the switch, the one on the bottom of the steering column under the dash and you are not getting power out of it to the high beams, then you need to replace the switch. Problem solved.
Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Super Moderator
Re: 1989 No High Beams
If you checked the switch, the one on the bottom of the steering column under the dash and you are not getting power out of it to the high beams, then you need to replace the switch. Problem solved.
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Level: Hummer (H2)
Re: 1989 No High Beams
ok how do i get the switch of the steering column do i have to lower the whole column or is there an easier way.
Last edited by deuce7931; 07-23-2010 at 08:42 PM.
Posting Permissions
Reply With Quote
Bookmarks