Now it is time to move to the passenger side of the vehicle. You already have a plate 16” long drilled for the cross member bolts. Now you need to make a decision. If you want a 4 link front, then you need to repeat the steps already mentioned and make a mirror image of the bracket on the driver side. If instead you are satisfied with as three link, as I am then you just need to cut two pieces of steel, one 1/4X6X2.5” for the inner part of the bottom link bracket and one the same size as the outer part of the lower link bracket and drill the same holes in the same places and weld these brackets in the same places as the other side. I elected to reuse the brackets I made with these relative dimensions that I used for my Y link that was on before.
Bookmarks