Re: How to build a 3 or 4 link suspension
Next, it is time to build the brackets for the rod ends. First start with a piece of 1/4X6X8” steel. Measure up 1” from the bottom and 2 ½” from the left side. Mark that and then measure up 4” and to the right 4” and mark that. Then drill two 9/16” holes. Then take two 9/16” nuts and weld one on one side of the plate and one on the other side so that you can bolt two joints on either side as shown in the pictures.
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Bookmarks