Re: How to build a 3 or 4 link suspension
Now it is time for the cross member. In the previous part of this build, it was neglected for a reason. I elected to have a removable cross member that can be removed without dismantling my suspension and future skid plates that I can remove also for service and repair without affecting my suspension. So the cross member will bolt in between the two brackets that have been welded in place. Remember the little piece of 1/4X26” flat bar that was drilled to fit the driver side bracket? We haven’t used it yet, but now is the time. It is welded to one end of the cross member that needs to be drilled for the transmission mount in the same position as the stock cross member. If you have a three link as I do, then you need to make another flat plate the same size or out of 1/4X2 1/2X6” flat bar for the other end. The difference is that this one has to have a hole large enough to clear the nut for the bolt for the passenger side lower link.
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Bookmarks