Re: How to build a 3 or 4 link suspension
Then cut a 1/4X3” flatiron 3 ½” long, just long enough to fit between the bolts on the 16” flat iron and not interfere. Drill a 9/16” hole 1 ¾” from the top and 1 ¾” from each edge and tack with a joint in place as shown. Next you can take it all down and tack in a 1/4X2 1/2X3” gusset in the rear behind the joint, making sure you don’t have any interference from the joint. Then weld it all together and paint the hard to get places. It should look like this when done.
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Bookmarks