I'm hoping to pop the cover off tomorrow after we finish my neighbors deck. As long as the caps are there ill start stripping and getting ready for the truss and 513s
Tapatalk is active for this site! Just go to your phone's store to download and install.
I'm hoping to pop the cover off tomorrow after we finish my neighbors deck. As long as the caps are there ill start stripping and getting ready for the truss and 513s
91 aw4 Dana 30 and 8.8 with 4.56s, 6in rough country long arm kit, hd offroad shackle relocation, 33s, Va fan full width front bumper, brown dog poly motor mount to go with a fresh long block.
In my never ending quest to see just how much I can make this axle weigh, I added a couple of tie down loops.. Whenever I load my Jeep on my trailer I have to wrap a chain around both sides of the axle and run it through a hook on the back of my trailer. Takes a lot of time and I get tired of messing with a 20' chain. So I got the rose bud going and bent up some 3/4" round stock and made a couple of loops I can hook into with open hooks. With the right length of chain, I can just hook into the loops and drive on to the trailer and when it stops, it will be just right. Similar thing intended for the front axle so trailering can be done quick and easy
Last edited by 4.3LXJ; 03-05-2018 at 05:59 PM.
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Bookmarks