Couldn't get the axle shaft into the press, just wouldn't make the bend to get into the center. So I got out the high tech slide hammer and installed axle bearings and seals. Paid good money when I was 17 to a Forde Garage to learn that trick
Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Super Moderator
Re: My Dana44 Axle Build
Couldn't get the axle shaft into the press, just wouldn't make the bend to get into the center. So I got out the high tech slide hammer and installed axle bearings and seals. Paid good money when I was 17 to a Forde Garage to learn that trick
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Posting Permissions
Reply With Quote
Bookmarks