Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Jeep Number 3
Re: My Dana44 Axle Build
FOr the front of my MJ I have a f250 hp 44. Im going to be using a tnt customs truss and brackets. I going to run it 5 lug instead of 8 lug so its only 67 inches instead of 69. That way its closer to the 65 inch; 9 inch in the rear. Also have a milled flat top to match the driver side so Im going to run hi steer. DId I mention I got the housing with machined pass. side knuckle, minus axles and carrier for FREE.
91 aw4 Dana 30 and 8.8 with 4.56s, 6in rough country long arm kit, hd offroad shackle relocation, 33s, Va fan full width front bumper, brown dog poly motor mount to go with a fresh long block.
Posting Permissions
Reply With Quote
Bookmarks