If it is just the rods you are worried about, I would pull the panel for the other door and just do a mirror image of what is there.
Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Super Moderator
Re: Write up request: Replacing Driver door Lock Actuator
If it is just the rods you are worried about, I would pull the panel for the other door and just do a mirror image of what is there.
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Level: Hummer (H3)
Re: Write up request: Replacing Driver door Lock Actuator
Lol, ya it was the rods. I started doing that. I got them on. The door opens from the inside but not from the outside. I see it moving something on the actuator but it wont open the door.
Posting Permissions
Reply With Quote
Bookmarks