Hmmm, if you have that inside handle working and if the door lock works, only one short one left. I don't have a write up on that. I would use the other side for a frame of reference
Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Super Moderator
Re: Write up request: Replacing Driver door Lock Actuator
Hmmm, if you have that inside handle working and if the door lock works, only one short one left. I don't have a write up on that. I would use the other side for a frame of reference
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Level: Hummer (H3)
Re: Write up request: Replacing Driver door Lock Actuator
apparently there is a hex nut on the actuator that needs to be tightened on new actuators. its accessed through the small hole on the side of the door once its installed.
Posting Permissions
Reply With Quote
Bookmarks