Did you mean 3 or 4
They're backwards ~ 4 is on the left
3 is the circular opening on the thrust bearing
It's actually fully centered.
The other (same as 5) less than 1/2 of it is open.
With a .002, is 1/2 blocked enough?
Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Site Subscriber!
Re: Crank bearing oil fees hole size?
Did you mean 3 or 4
They're backwards ~ 4 is on the left
3 is the circular opening on the thrust bearing
It's actually fully centered.
The other (same as 5) less than 1/2 of it is open.
With a .002, is 1/2 blocked enough?
Be strong when you are weak.
Be brave when you are afraid.
Be humble when you are victorious.
But be a badass everyday!
. . . . . . . . . . . . . . .
Posting Permissions
Reply With Quote
Bookmarks