Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Site Subscriber!
Crank bearing oil fees hole size?
I put the main bearings in and measured with Plastigauge
I'd estimate all at .0015
When I put the uppers in, I noticed the oil feed opening on the block is like 1/4" dia
The bearing opening is oblong, and has roughly 1/2 the opening as the block.
As well, the bearing's opening (all of them) are slightly out of line with the block.
How much smaller of an opening should the bearing feed hole be?
Sorry, I don't have pics at the moment.
Be strong when you are weak.
Be brave when you are afraid.
Be humble when you are victorious.
But be a badass everyday!
. . . . . . . . . . . . . . .
Posting Permissions
Reply With Quote
Bookmarks