The axle shafts hold the bearings together. You can either take apart you axle shafts and just use the outers in the bearings. Or get the little stub shafts they use on 2wd's. Or use a really big bolt with a nut on it.
Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Mall Crawler
Re: dana 30 front axle question
The axle shafts hold the bearings together. You can either take apart you axle shafts and just use the outers in the bearings. Or get the little stub shafts they use on 2wd's. Or use a really big bolt with a nut on it.
Level: Jeep Liberty
Re: dana 30 front axle question
Damn. Good thing you only drove 25 miles,you could've lost a wheel...
"Just some guy"
Re: Dana 30 front axle question
Get a spare, or two, of the 2 wheel drive wheel bearing assemblies.
Oh and a couple of these to cap off the tube ends.
Posting Permissions
Reply With Quote
Bookmarks