Robert, I can't tell that from here. Put a straight edge against it and see if the tubes are true. That is all I can tell you, and is what I would do if it were me. But unless you have hit something very hard, that is not likely the case
Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Super Moderator
Re: Wheel bearing/rear end replacement question?
Robert, I can't tell that from here. Put a straight edge against it and see if the tubes are true. That is all I can tell you, and is what I would do if it were me. But unless you have hit something very hard, that is not likely the case
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Level: Cherokee XJ
Re: Wheel bearing/rear end replacement question?
I will show a picture of the bearings with the inner race to my mechanic and see what he says. We shall see.
Thanks
For all your help
Posting Permissions
Reply With Quote
Bookmarks