Re: Track bar drop bracket measurement
I thought you had the bracket in hand. Not much I can tell you then if they won't supply you the info. But this would be worth a try. If I was building one I would use the same bushing as the other end. In which case the measurements would be the same as for the axle end of the track bar. Ask them about the replacement bushings for the track bar and if they are the same on both ends
Last edited by 4.3LXJ; 02-26-2014 at 10:59 PM.
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Bookmarks