Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Super Moderator
Re: Pinion seal lp dana30
This might be a tough one. I looked up your seal on Quadratec and it listed a change at 10/1/00, but no part number. A small mystery since the same seal fits everything else with a D30 after that. I would suggest getting the earlier seal that has the lip you mentioned and seeing how it fits
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Level: Hummer (H3)
Re: Pinion seal lp dana30
Thanks, I think I will just grab one for a 2000 xj and see how it goes. If my pinion style is the same as earlier xjs (not 2001) does that mean I may have a High Pinion front dana 30 under there? just curious.
Posting Permissions
Reply With Quote
Bookmarks