What's the best way to get rid of tie rod roll?
Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Level: Cherokee XJ
Tie rod roll
What's the best way to get rid of tie rod roll?
Super Moderator
Re: Tie rod roll
Do you have aftermarket steering?
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Level: Cherokee XJ
Re: Tie rod roll
Its stock except for I used a LHD drag link to flip everything to the top of the knuckles. Everything is tight and new except tie rod. All replaced about 3 months ago
Super Moderator
Re: Tie rod roll
You probably don't have tie rod roll then. I suggest that you may only need to adjust your steering box
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Level: Cherokee XJ
Re: Tie rod roll
I had someone turn the wheel back and forth and watched the drag link roll and pull the tie rod around with it. I used the adjuster between the drag link and the tie rod for the pitmon arm and put the steering in a bind and it took about 95% out. I'm just gonna come up with some money and replace the whole steering with otk setup or something stronger than stock
Level: Cherokee XJ
Re: Tie rod roll
Well I just ordered the iron rock Otk system. Hopefully it will be here by the weekend
Posting Permissions
Reply With Quote
Bookmarks