the 1st thing I am going to do is to strip the interior, except the dash and redo the floor-----gonna clean any bad spots and then prime and paint it with herculite roll on bed lliner----2 coats... Then install a full on roll cage front to rear with the rear bars becoming stantions near the tailgate instead of on the rear wheel wells..... Then i am going to re-inforce the exposed frame memebers under neath with 3 sided angle iron to support the frame...

Still have to figure out a way to hinge the tail gate at the bottom, so it will look halfway decent... But it will be re-inforced fully in the rare section, so i DON;T GET HAT FLEX....WELL i WILL TRY ANYWAY... But thanks for the heads up---you guys been doing this alot longer than me...