Huh. That must be new for IRO! Awesome!
Tapatalk is active for this site! Just go to your phone's store to download and install.
Huh. That must be new for IRO! Awesome!
Well I installed it and a few weeks later I did the strap to ubolt mod on my Dana 30.
Today I had a quick job to do on the Dana 35 on the 2003 TJ. I had ordered a set of ubolts for it as well, so a quick drilling out I could add a little extra strength to the axle side of the micro drive shaft that's on there. Short drive shaft.
Well I found out that the yoke it too think for the ubolts I have. I'm not sure if this is the case for all Dana 35s or just the one used on 2003 TJ, but it was a no go.
Sure am glad I held the ubolt up there before drilling.
Ok so lets run this through my non mechanical brain.
Can I buy these U-bolts at the hardware store like ACE? I have about a 4 day window to get the jeep fixed.
I can still drive it a few blocks to the repair shop. Is this an easy fix for them?
Can the repair shop pop out my 4 bolts and replace them with the correct size?
I was using bolts from a dana 35 and screwing them into the 8.25 which is why they are too tight. And one broke off.
Bookmarks