Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Super Moderator
The Right Stuff
I have some gasket maker I have been trying out. This stuff has been out for quite awhile. Instead of just silicone rubber, this stuff has a different formulation that works well. I have used it on my oil pan as a gasket in the Subaru and I can say it is impervious to synthetic oil.
The can is pressurized and is easy to use to put down a fairly uniform bead. Below is my valve cover gasket. I always have trouble with the rubber gasket that goes here because it slips and then leaks. Now it won't.
Last edited by 4.3LXJ; 01-14-2013 at 11:38 AM.
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Posting Permissions
Reply With Quote
Bookmarks