Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Super Moderator
Re: New to owning a Jeep and need some help!
No fuse really. You can check them, but those solenoids are controlled by the transmission control module, which is working if it is throwing codes at you. Tony (Mudderoy) replaced his. It is not hard. Since you have had the pan off, that is most of the work. Make sure all the wires are intact while you are at it.
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Level: Hummer (H2)
Re: New to owning a Jeep and need some help!
4.3LXJ .... ok when I was up under the jeep changing the filter before we took the transmission pan off we seen this plug that had 3 exposed wires coming off of it. As your laying on your back looking up at the pan it's like on top of the pan plugging into something and the only part we could see of it were the 3 exposed wires. There was also another plug that looks like it should have been plugged into something but it was just loose. Any ideas what those would be?
Posting Permissions
Reply With Quote
Bookmarks