Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Level: Hummer (H2)
Wiring problem
Well long story short, I came down my garage where my jeep was sitting and was gonna fire it up and...
Someone being a jagoff cut my harness, now with this one being my woods buggy should i reconnect the cut wires (P.I.T.A.) or can I just wire it for ignition, starter, fuel....
I hope you guys can help I am dying to hit the trails...
Super Moderator
Re: Wiring problem
Welcome to the site Boomhauers. Personally, I would reconnect them all. You cannot wire ignition only because the engine is run by a computer. I cannot tell from the pic which harness it is, but if you use some crimp connectors and then wrap them good and support the looms you should be good to go.
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Posting Permissions
Reply With Quote
Bookmarks