Re: HELP! Clutch or slave cylinder
When I bled mine before rolling it, I took the slave off and pointed the front down and then bled it. It worked a little better. Or you could jack up the rear enough that the back of the slave is higher than the front. Normally with the angle of the engine, the rear is lower and you cannot get all the air out of it.
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Bookmarks