**SOLD**
Tapatalk is active for this site! Just go to your phone's store to download and install.
Type: Posts; User: jschmidt250; Keyword(s):
**SOLD**
I have a brand new never installed Atlas II tcase. The specs are listed below.
Atlas II Speed Transfer Case
Gear Ratio: 3.8:1
Input Spline: 23 Spline Input (#A23)
Drop: Left hand Drop (Driver...
I have had no issues with my Yukon Zip Lockers.
When I had a similar issue, it was the the ignition switch. Contact looked discolored so I replaced it. That solved my problem.
I don't think it has been rewired. Looks like it is time to tear into the steering column!
Power source for interior fuse panel – fuse 2
I had been experiencing intermittent loss of power to my radio, cigarette lighter, wipers, and climate control. It would go out for a bit and come...
I run a Cherry Bomb
I’ve seen two different ways these attach.
The first is spring clip that goes over the entire ball stud, It just pops on/ off. The second is a thin wire that slides up into the cup on the strut...
You wont be disappointed with Ruffstuff.
Looks nice. This could be a future project for me.
I have a Warn Zeon 10-S I’m looking to sell. It is new in the box, never installed.
I would like to get $900 for it.
Please send me a PM if you are interested.
Thanks for the discount, I just ordered a Bumper/ Tire Carrier!!
I went with the OEM brake lines for a YJ. They gave me the extended length for the lift and have had no issues with them.
Yes I saw that video and I was a bit surprised about the China comment as well. I also saw Randy's video.
I figured I could save a few bucks and get a better warranty going with Yukon. I'm also...
I went with the Yukon Zip lockers front and rear. I got a good deal for the lockers and new ring/ pinion package I ran the air lines through air compressor hose to protect them from any chafing. I...
After sending the last few months going through and installing a new fan clutch and thermostat, as well as changing the injectors ans adding an adjustable fuel pressure regulator, I was finally tired...
I like that bumper. Very nice.
Here is my 93http://i1271.photobucket.com/albums/jj632/jschmidt250/IMG_0330.jpg
So it looks like I'm running a fuel regulator and injectors at 39psi/21.0lb/hr. The new intake setup should be running 49psi/22.5lb/hr.
If I understand this correctly, I'm not running enough fuel...
I'm not overheating, I just notice a higher temp.
I did not change the fuel pressure regulator when I swapped the injectors. If I’m not getting enough pressure to new injectors, that would...
I was thinking it could be lean as well. I'm going to look into the replacement injectors for the 00. If I remember correctly, they are larger than the 93 replacements.
Thanks
I recently swapped the intake manifold on my 93. I installed a newer design from a 2000. I also upgraded the injectors with a set of 0280155703 injectors.
Before the swap the temp never went over...
I used the 2 passenger side e-brake cable from a 1995 YJ.
The package came with an ARB compressor. I upgraded the compressor to the CKMA12 to inflate tires.
I have not noticed any more noise than I heard from my stock gears. If they do whine, I can't...
I just had the zip lockers installed. I think the warranty and price is hard to beat. I purchased them through RWK Haus Supply www.rwkhaussupply.com. They usually have package deals for the lockers...