I have to wait until I can make to the parts store to borrow a fuel pressure tester, but from everything I've read I'm pretty sure my fuel pressure regulator is bad. So here's my incredibly newb...
Tapatalk is active for this site! Just go to your phone's store to download and install.
Type: Posts; User: Superkirby; Keyword(s):
I have to wait until I can make to the parts store to borrow a fuel pressure tester, but from everything I've read I'm pretty sure my fuel pressure regulator is bad. So here's my incredibly newb...
Not an expert but I'm going to guess no. From what I could tell in searching before I replaced mine, it should be a smooth transition from around 5 to almost 0. If you aren't getting any change I...
BlueXJ, Mudderoy and anyone else that helped - THANK YOU!!!! My transmission problem was getting worse, to the point that last night I tried to drive it and couldn't get it to shift into third. I...
I just went out to try this. My connector is different. The one in the link is for an 89. Of course they would change it. Currently still looking around trying to figure it out. If anyone has...
Thank you very much for that link. I will try that. I went to work this morning and all was well. Stopped at a stop light about 10 miles from work, and after that it wants to shift even later. ...
First off, how do you calibrate a TPS? I thought they were all pretty much plug and play? And second, what do you think the chances are that a TPS is really the problem? It looks like a new one is...
Also, will it be set up so that with the switch off the fuel pump will still cycle on normally? Or once the switch is in will it have to be on for the vehicle to work?
After you do this, you should post a how-to. Very detailed please. Wiring scares me.
What all is involved in tapping a switch in? Thinking about it, while I don't see it being an issue right now, when it's -30 out this winter, it could be. Adding a switch seems like it could be...
It would take awhile for the 2 mpg to pay for itself at $1100 to swap gears. What I would really like to do - and from what I can tell it would cost the same or could maybe be done for a little less...
Now see, that sounds expensive.
Per the youtube video, that's about the same as mine. As far as I can tell my whole assembly is in the tank as well, correct? I very well may just leave it for a little while. Aside from taking a...
My 93 does the same thing. I just assumed it was the way it's supposed to work? For the most part, the roads I drive on regularly I can run about 65, maybe 70 tops. At 70 it will be fine unless I...
Ever since I got the Jeep, it's been a little hard to start. It doesn't matter if it's warm or cold, it takes several seconds of cranking. This can be slightly decreased by pressing the gas pedal,...
I have some cooler questions and I was going to start another post, but instead will just ask here.
First, what's makes a stacked plate style better than a tube and fin? Is it better enough to...
I took the Jeep out today and drove it around, got it good and warm then parked it on a level surface, left it in park per the dipstick and checked the transmission fluid. Good and red, doesn't...
I will double check fluid. I checked it the other day and it looked ok, but it's also possible the jeep wasn't entirely level. It seems like everything out here is sloped just enough to make things...
Thanks for all the responses. I'm glad I asked. I was pretty set on the filter. I used to have a 99 Exploder and the explorer group swears up and down that a filter is the way to extend the life...
Hopefully in the next few days I'm going to change the transmission fluid and filter on the Cherokee and I figure while it's empty-ish I might as well cut a line and add either a second filter or a...
No CEL, sorry for the confusion. I meant that in the past I've had 2 vehicles that had CEL's come on when they started shifting different. This one has no CEL and shifts the same every time.
I...
I have a 93 Cherokee with 83k and had a question about shifting. I know all vehicles shift a little different, and this is my first Jeep so it could be perfectly normal. So what's normal for a...
The first two pictures are exactly what I have. Well, what I should have. The second picture is just the rubber with nothing else there. The third picture looks like something that I could add...
Mine has a hanger just before the bend to start the axle. Just not sure if that's all that should be there. If the one I'm wondering about farther back is in fact supposed to be a hanger of some...
Nothings really rusted through yet. Just a lot of bubbling where it's started. The tank straps probably need to be replaced as they're starting to flake. There's a few other places but it's also...
...exhaust hangers should there be on my 93 Cherokee? I put a new muffler and tail pipe on tonight and it just has the one hanger on the tail pipe by the muffler. There's also some sort of rubber...