I have seen balancers come loose before,just not on a Jeep
Tapatalk is active for this site! Just go to your phone's store to download and install.
Type: Posts; User: cheap jeep; Keyword(s):
I have seen balancers come loose before,just not on a Jeep
I think it's a 23 spline,but I'm not sure.
I just got a 23 spline 231j trans case that I plan on changing the input shaft into a 242j for my jeep,hopefully it will all fit.
I am having trouble with my tv and this maybe the problem. Thanks for the idea
I worked on a F150,5 speed and they run a plastic bushing on the plunger rod on the pedal.The bushing was worn rather badly,so I changed it and it helped quite a bit.HTH
I would guess that it's the coil, I don,t about the tps,when my tps went bad the trans wouldn't upshift but the engine ran o.k.
If your Jeep is carrying good oil pressure, I would say it was probably all right to leave it alone,but I would replace it if I had it apart anyway,if it was mine.
I forgot to put on a Ranger onetime, I just took out the bellhousing bolts and pulled the trans back enough to clear the dowel pins and pushed the shield in and bolted it back up.It was a stick...
You might try a remote start manufacturer. When I installed my wife's remote(Bulldog) I went to their site,it helped a lot,they have wiring diagrams for about anything.
Melissa.have you tried plastic pvc pipe,if it gets broke, you just cut out a small piece and just glue a coupler in. This is the kind of pipe that is in most houses now for pressure and drainage.
I have been a production welder in 2 factories for a combined total of 35yrs. Find out how thick of steel the welder will work on in the instructions,usually 1/4 steel is thick enough unless you are...
I think I read somewhere that the 231amc was built before chrysler bought out amc,and afterwards it was called 231j.I think the 231 amc case will have21spline input and the 231j might have a 23spline...
When you hit the throttle briefly and a lot of smoke comes out it is usually an indication of blow-by.If you remove the oil fill cap and it looks like a milkshake that has a melted,this is caused by...
When you have your oil changed ,see how many qts. they put in(mine holds 6 with filter) and then see where it reads on the dipstick. Did this problem happen before it got really cold? I was wondering...
I had a Dodge 600 that would race some times and if you shut it off,then restarted it,it would idle. It ended up being the idle air control motor.(IAC) That was on a 2.2 tbi engine.
If 1 or more tires was a little low on air it would roll a little different distance,and possibly bind.
On my xj,it wouldn't upshift,I replaced the throttle position sensor and that fixed it.Mine is a 92.
If you want to check for vacuum leaks instead of using WD40 or starting fluid,you can use a propane torch,not lit. If it has a leak, it will rev the engine up a little,and if it does backfire and the...
If you call a salvage yard (junk yard) they can tell you. If you buy it, I would try changing the TPS before changing the trans. When I bought mine, it wouldn't shift, and this fixed it.
A salvage yard(junk yard) has a book called a Hollanders manual,it list"s almost all parts that will interchange.
I have read before that brake fluid draws moisture and should be changed every 2 yrs
Where can I buy a lunchbox locker,and an idea of cost?
Maybe they can be shot while trying to escape,no trial-no reports to file.
We have run fuel pumps on demolition derby cars this way and start buttons also.You can buy a heavy duty switch for the starter or run a relay(horn/light relay),about$4.50 at auto supply...
I don't have a digital camera.When I took CDL training the tractor we drove had a electric fan clutch,it worked thermostaticly and it had a switch also. That way if you left the truck idleing for a...