Hub Assembly and U-Joint

Just ordered some parts to change out my passenger side hub assembly(unit bearing) and u-joint. Here is what I ordered:
Timken Hub Assembly
Spicer 5-760 u-joint
Ball Joint Press for u-joint removal
36mm socket
25-250lb torque wrench.

Is there anything else that I am going to need for the job?

Also is there a good write-up with pics that anyone can point me in the direction of? Or any tips or tricks I should know before I continue?

I just rolled over 100k and the passenger side hub has started making noise, so we are going to see if this does the trick.

I think you probably have it covered. Might need a new cotter pin if you cannot reuse the one you have