Printable View
with the new tcase i put in and redid the sye. i left the output a little longer this time but now i have vibrations. the longer output makes the drive shaft hard to fit in. at ride height it has no up travel slip. im assuming this is where my vibs are coming from. so would adding shims fix this or do i need to make the rear lift lower or make the tcase out put shorter? i dont want to pull the case agin after all the hassle i had getting it in.
Does this have a hack n tap on it?
yea sorry it does.
And by your description, your drive shaft has no telescoping travel left in its current position?
correct none when the axle would cycle up. like its as short as it goes.
First thing is that you will need to shorten that tail shaft. Otherwise you will be replacing something else shortly. Whatever the weakest link is. That may be the source of your vibes also, but hard to tell until you get it set up correctly
so how short does the tail shaft need to be then? the first time i did it it was at the minimum. and i blew that case up.
That I cannot answer. It needs to be short enough that when the suspension is fully cycled it does not bottom out. But if you are bottoming out now, probably two inches shorter anyway
ugh that sucks. i just got it back in there this week. but yes the shaft is fully collapsed at ride height.
On second thought, take an inch off the shaft. I think that would work out better
grrrr this makes me so annoyed. not at you just this stupid tcase
I know, ain't it fun :smiley-scared003:
love it i wouldnt have modded if it wasnt
at least i can take the case out in a few minutes now cause im a pro
There you go, practice makes perfect :D
gee thanks man
we aim to please :rolleye0012:
yeah yeah