Gonna need to get the knife out for that one :D
Printable View
Gonna need to get the knife out for that one :D
Knife, sawzall, plasma cutter! It will fit!
Don't forget the big shoe horn
Ye of little faith Steve, when have you known me to fail??
Besides this thread....my first wife.... Alright I'm shutting up now 😢
Discretion is the better part of valor here Dana :D
Pfft! I have none of that valor stuff!
http://tapatalk.imageshack.com/v2/14...302e6167ad.jpg
http://tapatalk.imageshack.com/v2/14...a4234740f5.jpg
http://tapatalk.imageshack.com/v2/14...5278273300.jpg
Slight modification to make it fit but boy does it pump out the heat! Around 180 deg!
Oh man, that sounds good. My core needs replacing and I was going to gloat that the early XJs had a three piece HVAC so you can replace the core without removing the dash. Buuuuttt, I might rethink that
I got a slightly used core you can have!
Really? it will match the one I already have
http://tapatalk.imageshack.com/v2/14...4747c3c984.jpg
Top one in this pic, it's what I was using before, think it was too small, did not get too warm, the whole reason I went on this quest.
What core did you use?
The one on the bottom is from the rear heater on a 81 suburban, I think, part number 94556.
Interesting. I take it you had to get rid of the blend door?
Yup it's gone