-
94 4.0 stalling now
I replaced my dizzy to block gasket a few days ago, the jeep ran fine until I found out the internal gasket in the dizzy was my leak. I was typing on here in another thread went out and started it, by the time I made it back to the door to grab money and phone the thing died. Never happened to me before. Not sure whats up not, as I said it ran fine up until about an hour ago. Ive been searching and come up with everything from a pick up coil to ign coil to crank sensor....
It restarts right away, wont allow me to give it gas as it sputters, leave it alone it goes to 1500rpm down to 700 rpm down to zero in under 10 seconds. No other power is lost just ignition.... I dont have much time and need to get this fixed. New dizzy is ordered but need the jeep for work tomorrow.
Thanks in advance for any and all help.
I do have a meter to test electrical.
-
Re: 94 4.0 stalling now
I think the first place to look is what you worked on last. Did you time the distributor correctly? Mudderoy has a thread here somewhere on that
-
Re: 94 4.0 stalling now
It never moved, I was very careful when I removed and installed it a few days ago, but it ran fine tuesday and wednesday then today I get 30 seconds of run time, if gas is given it sputters and has the feeling like low power, I did notice a strong puff of fuel smell a few minutes ago when I was checking the CPS wiring.
I saw the write up its open in a tab but im just not able to pin this one down. I also cleaned and cannot see timing marks at all.
-
Re: 94 4.0 stalling now
http://tapatalk.imageshack.com/v2/15...c0b91ff74b.jpg
http://tapatalk.imageshack.com/v2/15...11078ebeeb.jpg
I removed the cap the e fan and the mech fan shroud. Set tdc #1 and without moving dizzy it shows im lined up right. Black mark on dizzy if from 2 days ago to mark rotor position which was #1 on cap as well.
-
Re: 94 4.0 stalling now
-
Re: 94 4.0 stalling now
Nothing man thats the kicker. My cps is newer the cam sensor had oil on it i cleaned it up. Iac was recently cleaned when i did a tune up in november. Fuel fikter all that good fun stuff but im hearing downstream o2 and or cps....
-
Re: 94 4.0 stalling now
I would check the TPS. I would rule out electrical and fuel injector stuff.
-
Re: 94 4.0 stalling now
-
Re: 94 4.0 stalling now
WOT tps is at 200 and goes up and down from 0 to 200 with plate position.
Not sure where to go now. Haynes shows an auto shut off relay in the wiring diagram, i had a spare good one and replaced it with same results. I have plenty or fuel pressure no gauge but shot it across the garage with schrader valve plunge. I got a feeling its going into the shop might be more than my tool box can handle
-
Re: 94 4.0 stalling now
I am a little stumped too
-
Re: 94 4.0 stalling now
Other then the rich smell and dying out it runs well idles very well
-
Re: 94 4.0 stalling now
Just for giggles, check your cat. Might be falling apart and plugging up the exhaust
-
Re: 94 4.0 stalling now
Ill give it a good smacking after work tomorrow i pushed it in the garage til tomorrow. Garage= carrage house no electricity
-
Re: 94 4.0 stalling now
-
Re: 94 4.0 stalling now
Thanks man i appreciate it.