What did you break on your Jeep today?

[JENSSEN]

An homage to the thread "what did you do to your Jeep today" may I present the thread what did you break on your Jeep today,..?



I will start with a blown u-joint cap on the 04 Rubicon winter wheeling after a few good stucks,....

[Niac]

Just the e-brake cable. It's a Lokar and only a couple of months old. Of course I won't have the reciept.

[prcjeep]

Power steering is completely gone now after yesterday's wheelin trip and my front right brakes are sticking

[Mudderoy]

Power steering is completely gone now after yesterday's wheelin trip and my front right brakes are sticking

How do you do this stuff Patrick? :rolleye0012:

[rguignard]

well it looks like the tracbar

[prcjeep]

How do you do this stuff Patrick? :rolleye0012:

Well the brakes.. No idea... just age of the brake cylinder?? But the powere steering pump's been leaking for about a month and ive just kept adding fluid... but now its not really leaking and its a b!tch and a half to turn

[Mudderoy]

Well the brakes.. No idea... just age of the brake cylinder?? But the powere steering pump's been leaking for about a month and ive just kept adding fluid... but now its not really leaking and its a b!tch and a half to turn

Well if I remember correctly that's only about $40...

[BigJeepBigJeep]

Broken fuel line at creekside :P

[msmoorenburg]

My wallet i had to fill it up :bang:

[XJ4IV]

Well the brakes.. No idea... just age of the brake cylinder?? But the powere steering pump's been leaking for about a month and ive just kept adding fluid... but now its not really leaking and its a b!tch and a half to turn

I had TONS of fluid leaking and I poured in the lucas stop leak and it totally stopped leaking!

[Weldmen]

ok...

[cantab27]

How do you do this stuff Patrick? :rolleye0012:

um ,,,jim and renes school of wheeling have anything to do with it:rolleye0012:

[prcjeep]

um ,,,jim and renes school of wheeling have anything to do with it:rolleye0012:

I didnt really learn from their school of wheelin... But I also noticed that i broke this on my Jeep...:bang:

http://i936.photobucket.com/albums/ad210/prcrawfo/0426111447.jpg

[XJ4IV]

I didnt really learn from their school of wheelin... But I also noticed that i broke this on my Jeep...:bang:

http://i936.photobucket.com/albums/ad210/prcrawfo/0426111447.jpg

Heeeeyyyyy I did that same thing... flexing out on a VW bug!
I got BOTH replaced by javiers crawl shop for 118$ I know it sounds expensive but its worth it if your keeping the 30

[saar]

Rear bushings, only a little more than a year on the jeep and have to replace them...

Saar

[BigJeepBigJeep]

I bent the part that attached to the spindle on the passenger side... don't remember what it's called. Hit a pothole in a trail covered in brush.... fml.

[LizardRunner]

don't know if I broke it or it just wore out but I've been having issues with the volt meter not reading 14 like it used to. Checked the battery, 12volts, started da lizard, still 12 volts, turned on the lights and still 12 volts, so now I'm hoping it's just the gauge has decided to die. This morning, started up and huge puff of smoke. Now I'm wishing I was a mechanic.

[steph74]

Will have to see as well how it turns out but it looked like the cooling system was acting up.... jeep was not overheating but the coolant started boiling over in the coolant bottle and made it out through the cap... it could be that the cap was not on ttight enough or that some of the hoses are in need ot be changed...

To follow ;)

[jccatt]

After coff's trip I have a tweety bird under the truck

[jccatt]

Chirping fixed. Just needed to clean and re-grease cardin joint.

[XJ4IV]

well... I FIXED a big tranny/ T-case issue but I found out when I put the shift solenoids back in the plug broke so I made a new connection but I think it didnt make contact cause I dont have 2nd gear... but other than that the jeep is no longer leaking ANYTHING and is running great

[prcjeep]

pictures are worth a thousand words...:bang:


http://i936.photobucket.com/albums/ad210/prcrawfo/0507110813.jpg

http://i936.photobucket.com/albums/ad210/prcrawfo/0507110813a.jpg

http://i936.photobucket.com/albums/ad210/prcrawfo/0507111118.jpg

http://i936.photobucket.com/albums/ad210/prcrawfo/0507111118a.jpg

http://i936.photobucket.com/albums/ad210/prcrawfo/downsized_0507111119.jpg

http://i936.photobucket.com/albums/ad210/prcrawfo/downsized_0507111119a.jpg

:boohoo::boohoo:

[Metlic53]

how'd ya do that prc

[XJ4IV]

X5000... do I see daylight where I should see floorboard???

[msmoorenburg]

pictures are worth a thousand words...:bang:



http://i936.photobucket.com/albums/ad210/prcrawfo/0507111118.jpg



:boohoo::boohoo:


Houston we have a problem!!!!!! I think you cracked the ear off the block :smiley-scared002:

[Mudderoy]

Houston we have a problem!!!!!! I think you cracked the ear off the block :smiley-scared002:

Remove steering wheel, tow old jeep off, roll new one into place, install steering wheel!

[prcjeep]

how'd ya do that prc
U-Joint blew up at about 70-75MPH... Shock went threw the tcase and tranny and cracked the Bell housing all the way around... Also twisted the output shaft for the rear DS on the tcase... Clutch chewed itself up too.

X5000... do I see daylight where I should see floorboard???
no thats light in that picture because the hoods open


Houston we have a problem!!!!!! I think you cracked the ear off the block :smiley-scared002:

Yeah... hope that's not too big a deal lol(compared to everything else)


Remove steering wheel, tow old jeep off, roll new one into place, install steering wheel!

Let me know when you're bringing yours over! :smiley-laughing021::smiley-laughing021:

[jccatt]

Ha ha I broke my other tail light:smiley-scared002:. So I bit the bullet and ordered some local ones. $220 delivered for the pair.

[Mudderoy]

U-Joint blew up at about 70-75MPH... Shock went threw the tcase and tranny and cracked the Bell housing all the way around... Also twisted the output shaft for the rear DS on the tcase... Clutch chewed itself up too.

no thats light in that picture because the hoods open



Yeah... hope that's not too big a deal lol(compared to everything else)



Let me know when you're bringing yours over! :smiley-laughing021::smiley-laughing021:

No way! I don't want to see my Jeep suffer the same fate! :shocker:

[Mudderoy]

U-Joint blew up at about 70-75MPH... Shock went threw the tcase and tranny and cracked the Bell housing all the way around... Also twisted the output shaft for the rear DS on the tcase... Clutch chewed itself up too.

no thats light in that picture because the hoods open



Yeah... hope that's not too big a deal lol(compared to everything else)



Let me know when you're bringing yours over! :smiley-laughing021::smiley-laughing021:

BTW, you do understand that with that piece broken off your BLOCK and it being cast iron that means you need to replace the block? :thumbdown:

I heard it may be able to be tig welded but that's a coin toss if it will hold.

[XJ4IV]

ok my vote goes to patrick for worst break of the year....

[OrangeXJ]

ok my vote goes to patrick for worst break of the year....

X2

[jccatt]

X3 thats a big list

[prcjeep]

So everyone keeps telling me that when I break stuff... i do it break it reallll good.

Here what is currently broken.

http://i936.photobucket.com/albums/ad210/prcrawfo/0625111535.jpg

http://i936.photobucket.com/albums/ad210/prcrawfo/0625111535a.jpg

Thats the front output shaft of my t-case... Rene and Donna have some pictures of me climbing the dirt wall that I did this on

[vwfoolwhy]

I have seen that same damage on a 98 Ram 1500.

We welded the bell housing back together as well as the Ears on the Block.

The T-case was a total lost but luckily we were able to convince the dealer to cover it under warranty. this was in 1998.

[prcjeep]

I feel like this thread is more like "what did Patrick break on his Jeep today?" lol

[Mudderoy]

I feel like this thread is more like "what did Patrick break on his Jeep today?" lol

Well it seems most of us here are daily drivers so we have more WEAR issues and you have more TEAR issues. :D

[BigJeepBigJeep]

Ha patrick my buddy called me after he talked to you at raceway in crosby when you were broken. Bummer man. Wish you would've just needed a jump again.

Sent from my SGH-T839 using Tapatalk

[XJ4IV]

Patrick... that aint TOO bad a fix actually pretty simple and the parts are EVERYwhere... all your gonna need for removal and installation other than basic tools is a pair of snap ring pliers... not the ones that make the ring SMALLER but the ones that expand the rings...
but yea you gotta pop that case open!

[Chaos in Bloom]

The motor. :(

[cantab27]

The motor. :(

more details please............................................ ..............:eek: