View Full Version : will i need a new D-shaft?
Metlic53
04-20-2011, 10:46 AM
Fixing to put a dana 44 in the 97 and it had a 8.25 in it already. it doesn't have a sye yet and has about 4 inches of lift. will my stock driveshaft work with the dana 44? may be too short? post count is down so i figured i could muster up some posts
Thanks!
msmoorenburg
04-20-2011, 10:51 AM
I think you will be good from what i've seen. I think the d44 is a little longer so it would help not hinder
dabarrett3
04-20-2011, 09:53 PM
You should be good to go up to 4.5 inches of lift, then you'll need SYE and drive shaft.
XJ4IV
04-21-2011, 10:30 PM
I think you will be good from what i've seen. I think the d44 is a little longer so it would help not hinder
it will assist... pushes the yoke further back on the output shaft so your fine!
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.